NON SHRINKABLE INSULATION TAPE

NON SHRINKABLE INSULATION TAPE

Product Details:

X

Product Description

Gala Non Shrinkable Insulation Tape is an EPR based insulation tape possessing excellent electrical, chemical and physical properties. it maintains a tight insulation built up without any voids giving good electrical stability and resistance to moisture penetration. Compatible with most commonly used Cable Jackets i.e. XLPE, PVC, PILC or Rubber Sheathed Cable.

Technical Specification

All dimensions are in mm

  • Properties
  • Test Method
  • Nominal Value
  • Physical:
  • Tensile Strength
  • BS 903
  • 3 MPa
  • Elongation
  • BS 903
  • 900%
  • Thickness
  • -
  • 0.75mm
  • Electrical:
  • Dielectric Strength
  • ASTM D149
  • 42 kV/mm
  • Dielectric Lose Angle
  • ASTM D149
  • 0.005
  • Volume Resistance
  • ASTM D257
  • 1 x 1013 Ohm.m
SELECTION CHART

All dimensions are in mm

  • Gala Size
  • W (Min.)
  • Thick.
  • L (Min.)
  • GGNT 1
  • 25 mm
  • 0.75mm
  • 9.1 Mtr.
  • GNT 2
  • 50 mm
  • 0.75mm
  • 10 Mtr.
Features & Benefits:
  • The tape has the property of cold flow, thereby when applied with 50% overlap, different layers, sticks with each other resulting into formation of void free insulation.
  • Excellent resistance moisture, contamination and adverse environmental conditions.
  • Excellent UV stabilized & weather resistant.
  • High heat dissipation helps to keep the conductor cooler.
  • Provides protection to the conductor material againstcorrosive elements present in the environment.
  • Standard Color: Black
Installation Instructions:
  • Keep open end of the tape on the start position of the cable to be insulated and then stretch the tape so as to reduce the width to 2/3 of its original width and then start wrapping 2/3 width tape with 50% overlap continuously around the cable till no portion is left uninsulated. Then repeat the taping process till the desired insulation & thickness is achieved.
  • The tape should be applied in successive half lapped, level wound layers until desired build up is reached. To eliminate voids in critical areas, highly elongate the tape. Stretch the tape in these critical area just short of its breaking point. In less critical area, less elongation is sufficient. Stretch 3/4 of its original width in less critical area.
  • Always attempt to half lap to produce a uniform build up.
Recommendations:
  • Care should be taken to avoid direct contact betweenthe tape and petroleum type solvents and oils. Oils may affect the electrical properties of the tape.
  • The rolls should be stored flat on their cut edges in theoriginal packaging. The product must be protected dust, heat, moisture, direct sunlight and solvent fumes. Storage temperature between +100C and +300C. Under these conditions, the storage life of the tape in a temperature climate will be at least five years.
Enter Buying Requirement Details
Email Id
Mobile number


Back to top